Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Buy Weber Grill Parts. It couldn't be easier. Find your Weber parts here.
22
WWW.WEBER.COM
®
OPERATING INSTRUCTIONS
USING THE ROTISSERIE
Note: Before using your rotisserie, measure your food at the widest point. If it exceeds
9½” (241.8mm), it is too large to fit the rotisserie. If it is too large, food can be prepared
using a roast holder and the Indirect Cooking Method.
IMPORTANT SAFEGUARDS
ƽ WARNINGS
• Read all instructions before using your rotisserie.
• This rotisserie is for outdoor use only.
• Remove motor and store in a dry place when not in use.
• Do not touch hot surfaces. Use barbecue mitts.
• This rotisserie is not for use by children.
• To protect against electrical hazards do not immerse cord,
plugs, or motor in water or other liquids.
• Unplug the motor from outlet when not in use or before
cleaning.
• Do not use rotisserie for other than intended use.
• Make sure motor is off before placing it on the motor
bracket.
• Do not operate the rotisserie motor with a damaged cord or
plug.
• Do not operate the rotisserie motor if it should malfunction.
• The rotisserie motor is equipped with a three prong
(grounding) power cord for your protection against shock
hazard.
• The power cord should be plugged directly into a
properly grounded three prong receptacle. If use of an
extension cord is required, be sure that it is a minimum
16 AWG(1.3mm), 3-wire, well insulated cord marked for
OUTDOOR USE ONLY and properly grounded.
• When using an extension cord, make sure it is not in
contact with a hot or sharp surface.
• Outdoor extension cords should be marked with the letters
“W-A” and a tag stating “Suitable for use with outdoor
appliances”.
• Do not cut or remove the grounding prong from the
rotisserie motor power cord.
• Do not let cord hang over any sharp edge or hot surface.
• To reduce the risk of electric shock, keep extension cord
connection dry and off the ground.
• A short power cord is supplied to reduce the risk of
tripping over the cord. Extension cords may be used, but
caution must be taken to prevent tripping over the cord.
• In absence of local codes the rotisserie motor must be
grounded electrically in accordance with the National
Electric Code, ANSI / NFPA 70, or Canadian Electrical
Code, CSA C22.1.
ƽ WARNING: Setup up the rotisserie with food before lighting
rotisserie burner.
OPERATING
1) To set up rotisserie motor, push the button on the retractable rotisserie panel(a).
Pull rotisserie panel towards you until it snaps into place(b).
2) Remove power cord and plug into power source.
4) Push the rotisserie shaft through the center of the food. Insert the tines of both spit
forks into the food. The food should be centered on the shaft. Tighten the spit fork
screw(c).
5) Slide another spit fork onto the rotisserie shaft, making sure that the spikes face
to the right and the fork screw faces up. Insert the tines of both spit forks into the
food. Tighten the spit fork screw(d).
ƽ CAUTION: Do not route rotisserie motor power cord through
the retractable rotisserie opening in the side table.
ƽ CAUTION: Inspect power cord before each use. If cord
is damaged, do not use. Contact the Customer Service
Representative in your area using the contact information on
our web site. Log onto www.weber.com
®
.
3) Slide one of the spit forks towards the right side of the rotisserie shaft, making sure
that the spikes face to the left and the fork screw faces down.