Weber 41081 Gas Grill User Manual


  Open as PDF
of 34
 
D-16
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(10)
(9)
To Clean the Burner Head
Remove the windshield and grate. Remove the burner
cap. Clean with soap and water. Soak if necessary.
Remove the burner ring. Clean with soap and water.
Soak if necessary.
ƽCAUTION: Do not enlarge the slots in the burner
ring. Only clean with a cloth and soap and water.
Remove the burner head. Clean with soap and water.
Soak if necessary.
Wipe out the burner base with a damp cloth and soap
and water.
ƽCAUTION: Avoid getting water or dust in the
burner orifice.
Clean the ignition electrode with a damp cloth and
soap and water.
1) Windshield
2) Grate
3) Burner Cap
4) Burner Ring
5) Lug
6) Slots
7) Burner Head
8) Igniter electrode
9) Burner Orifice
10) Burner Base
To Reassemble the Burner Head
Insert the burner head into the burner base. Figure 19
(c). There is a hole in the burner head for the igniter
electrode.
Set the burner ring onto the burner head. Rotate the
burner ring until the four lugs on the burner ring are
seated in the four slots on the burner head. Figure 19
(b).
ƽWARNING: If the flame pattern is uneven or
erratic, turn OFF the burner control knob. Check
the position of the burner ring to the burner head.
The lugs of the burner ring must be in the slots of
the burner head.
Install the burner cap. Figure 19 (a). Install the grate
and the windshield.
1) Windshield
2) Grate
3) Burner Cap
4) Burner Ring
5) Lug
6) Slot
7) Burner Head
8) Igniter Electrode
9) Burner Base
10) Burner Orifice
Burner assembly consists of: burner cap, burner ring,
burner head, burner base, and burner orifice.
Note: The burner head has a hole in it that fits over
the igniter electrode.
 previous