Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Buy Weber Grill Parts. It couldn't be easier. Find your Weber parts here.
WWW.WEbER.com
®
31
SEAR STATIoN
®
TRoUbLESHooTING
PRobLEm cHEcK SoLUTIoN
Burners burn with a yellow or
orange flame, in conjunction with
the smell of gas (This is normal for
the burner lighting tube).
Sear Station
®
burner does not light.
Inspect Spider/Insect Screens for possible obstructions. (Blockage
of holes.)
Clean Spider/Insect Screens (refer to “ANNUAL MAINTENANCE”).
Did you ignite the two adjacent main burners? (Refer to “SEAR
STATION
®
IGNITION & USAGE” instructions for safe lighting
procedure)
Verify adjacent main burner ignition by visual inspection of a flame.
m WARNING: If ignition does not occur in five
seconds, turn burner control OFF, wait five
minutes to let the gas clear before you try
again
Does Burner light with a match? If you can light Burner with a match, then check the Crossover
®
Channel on the sear burner (refer to “MAINTENANCE” for burner
removal and cleaning procedure).
Does the igniter work (Do you see a spark when you repeatedly
use the snap igniter?)
Try manually lighting the burner (refer to “SEAR STATION
®
IGNITION & USAGE”). Call customer service.
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our
web site. Log onto www.weber.com
®
.
RoTISSERIE TRoUbLESHooTING
GRILL oUT™ HANDLE LIGHT TRoUbLESHooTING
PRobLEm cHEcK SoLUTIoN
Weber Grill Out™ Handle Light
does not light.
Are the batteries old? Replace batteries.
Are the batteries installed correctly? Refer to assembly illustration.
Is the lid in the up position with the power button ON? Light will activate when lid is open.
Is the Weber Grill Out™ Handle Light activated? Press the power button.
Is the Weber Grill Out™ Handle Light positioned correctly on the
handle?
Adjust position (refer to assembly illustration).
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our
web site. Log onto www.weber.com
®
.
PRobLEm cHEcK SoLUTIoN
Rotisserie burner does not light. Did you hold the burner control knob in and hold in for 20 seconds
until after burner ignited?
Try to relight burner by holding burner control knob in and continue
holding in until 20 seconds after burner has ignited.
Did you wait to see the entire ceramic surface become alight
before counting 20 seconds?
When relighting burner by holding burner control knob in, wait to
see the entire ceramic surface become alight before counting 20
seconds?
Did you repeatedly use the snap ignition until the burner ignited? After waiting five minutes for gas to clear, try repeatedly using
the snap igniter until the burner ignites (refer to “ROTISSERIE
BURNER IGNITION & USAGE”).
Does the igniter work? (Do you see a spark when you repeatedly
use the snap igniter?)
Try manually lighting the burner (refer to “ROTISSERIE BURNER
MANUAL IGNITION”). Call customer service.
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our
web site. Log onto www.weber.com
®
.