Weber 89962 Gas Grill User Manual


  Open as PDF
of 68
 
12
3
1
2
6
4
5
GaS INSTrUcTIoNS
REFILLING THE LIQUID PROPANE CYLINDER
We recommend that you refill the LP cylinder before it is completely empty.
Removal of the LP cylinder:
A) Close cylinder valve (turn clockwise) (1).
B) Unscrew regulator coupling by turning counterclockwise, by hand only (2).
C) Lift cylinder out of cabinet.
To fill, take the LP cylinder to a gas propane dealer, or look up “gas-propane” in the
phone book for other sources of LP gas.
m WARNING: We recommend that your LP cylinder be filled
at an authorized LP gas dealer, by a qualified attendant,
who fills the cylinder by weight. IMPROPER FILLING IS
DANGEROUS.
m CAUTION: Place dust cap on cylinder valve outlet whenever
the cylinder is not in use. Only install the type of dust cap
on the cylinder valve outlet that is provided with the cylinder
valve. Other types of caps or plugs may result in leakage of
propane.
◆
1
2
Check
A) Hose-to-manifold connection (1).
B) Side burner hose-to-manifold connection and side burner hose-to-side burner gas
line connection (2).
C) Side burner hose-to-side burner connection, side burner valve and orifice
connections (3).
m WARNING: If there is a leak at connection (1, 2, or 3), re-
tighten the fitting with a wrench and recheck for leaks with
soap and water solution. If a leak persists after re-tightening
the fitting, turn OFF the gas. DO NOT OPERATE THE GRILL.
Contact the Customer Service Representative in your area
using the contact information on our web site.
Log onto www.weber.com
®
.
D) Regulator-to-cylinder connection (4).
E) Hose-to-regulator connection (5).
F) Valves-to-manifold connections (6).
m WARNING: If there is a leak at connections (4, 5 or 6), turn
OFF the gas. DO NOT OPERATE THE GRILL. Contact the
Customer Service Representative in your area using the
contact information on our web site.
Log onto www.weber.com
®
.
When leak checks are complete, turn gas supply OFF at the source and rinse
connections with water.
Reinstall Control Panel
You will need: Phillips screwdriver.
A) Reconnect the igniter wires to the ignition module.
B) Carefully position control panel down and onto frame.
C) Reinstall machine screws at lower left and right side of control panel with a Phillips
screwdriver.
D) Reinstall screw and washer onto the back of the control panel with a Phillips
screwdriver.
E) Replace burner control knobs.
◆
 previous next