Weber 89960 Gas Grill User Manual


  Open as PDF
of 60
 
22
ELECTRONIC CROSSOVER
®
IGNITION SYSTEM OPERATIONS
If the Electronic Crossover
®
Ignition System fails to ignite the BURNER 1, light BURNER
1 with a match. If BURNER 1 lights with a match, then check the Electronic Ignition.
• Checkthatbothoftheignitionwiresareattachedattheignitermoduleproperly.
• CheckthattheElectronicIgnitionbuttonisworkingbylisteningandlookingforsparks
at BURNER 1.
Replace Battery If Necessary
AAA alkaline battery only.
If the Electronic Crossover
®
Ignition System still fails to light, contact the
Customer Service Representative in your area using the contact information on
our web site. Log onto www.weber.com
®
.
◆
ANNUAL MAINTENANCE
Inspection And Cleaning Of The Spider/Insect Screens
To inspect the Spider/Insect screens, remove the control panel. If there is dust or dirt on
the screens, remove the burners for cleaning the screens.
Brush the Spider/Insect screens lightly with a soft bristle brush (i.e., an old toothbrush).
m CAUTION: Do not clean the Spider/Insect screens with hard
or sharp tools. Do not dislodge the Spider/Insect screens or
enlarge the screen openings.
Lightly tap the burner to get debris and dirt out of the burner tube. Once the Spider/
Insect screens and burners are clean, replace the burners.
If the Spider/Insect screen becomes damaged or cannot be cleaned, please contact the
Customer Service Representative in your area using the contact information on our web
site. Log onto www.weber.com
®
.
Burner Flame Pattern
The Weber
®
gas barbecue burners have been factory set for the correct air and gas
mixture. The correct flame pattern is shown.
A) Burner tube (1)
B) Tips occasionally flicker yellow (2)
C) Light blue (3)
D) Dark blue (4)
If the flames do not appear to be uniform throughout the burner tube, follow the burner
cleaning procedures.
◆
3
1
2
4
maiNTENaNcE
 previous next