Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Buy Weber Grill Parts. It couldn't be easier. Find your Weber parts here.
12
3
1
Gas iNsTrUcTioNs
A) Open base cabinet doors.
B) Pass the regulator hose through the side panel opening to the inside of the base
cabinet. (1)
C) Slide the hose retention bracket (2) along the hose and through the side panel
opening to the inside of the base cabinet.
D) Position the hose retention bracket on the right inside panel and secure with two
hex/washer/bolts (3).
m WARNING: The hose must be secured to the side panel with
the Hose Retention Bracket. Failure to do so could cause
damage to the hose resulting in a fire or explosion which
can cause serious bodily injury or death, and damage to
property.
The LP cylinder is installed inside the base cabinet.
E) Turn the LP cylinder so the opening of the valve is either to the front or side of the
Weber
®
gas barbecue.
F) Lift and place the cylinder into the tank base opening in the bottom panel (4).
Weber recommends the use of cylinder manufacturer’s Manchester and Worthington,
with a 47.6 lb water capacity. Other cylinders may be acceptable for use with the
appliance provided they are compatible with the appliance retention means.
Connect The Hose To The Cylinder
A) Remove the plastic dust cover from the valve.
B) Screw the regulator coupling onto the tank valve, clockwise, or to the right (5).
Hand-tighten only.
Note: This is a new type of connection. It tightens clockwise and will not allow gas to
flow unless the connection is tight. The connection requires tightening by hand only.
m WARNING: Do not use a wrench to tighten the connection.
Using a wrench could damage the regulator coupling and
could cause a leak.
2
4
5