Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Buy Weber Grill Parts. It couldn't be easier. Find your Weber parts here.
11
Step 15
Put the control panel back on
Set the control panel in place over both frame braces.
(Hold the Crossover Ignition button up while setting the
control panel in place.) Place your thumbs over the
control panel push-in buttons, and push them into the
frame brace until they snap into place. Figure 25 (a).
Push on the burner control knobs. Figure 25 (b).
Figure 25
(a)
(b)
Figure 26
Step 16
Install glass doors
You will need: one LH glass door assembly and two RH
glass door assemblies.
Start with the LH door assembly. Insert the long hinge
pin at the top of the door into the plastic bushing in the
underside of the left frame. Insert the bottom (short)
hinge pin into the bushing in the frame connector.
Repeat the procedure with the RH door assemblies. The
glass doors latch on the frame connector. Figure 27.
Figure 27
Bushing in frame
connector and
short hinge pin
Bushing in the
underside
Bushing in underside
and long hinge pin
Pull the right hand swing table up. Stand to the right
side of the barbecue. Slightly pull back both side burner
locks. Slide the side burner toward the control panel.
The locks will snap into the slots in the front and back of
the side burner. Figure 26.
ƽCaution: Make sure both locks have snapped
into place.
View from top
Side view