Weber 57503 Gas Grill User Manual


  Open as PDF
of 56
 
20 WWW.WEBER.COM
®
ROUTINE MAINTENANCE
IGNITION SYSTEM OPERATIONS
The igniter supplies a spark to the igniter electrode
assembly. Whether you are performing routine
maintenance or a troubleshooting check on the ignition
system, read the following to keep your ignition system
working properly.
m WARNING: All gas controls and supply
valves should be in the OFF position.
If the igniter fails to ignite your Q
®
grill, you will need to
pinpoint where the problem is occurring: with the gas flow
or with the ignition system. Begin by attempting to match
light your burner. Refer to “BURNER IGNITION—Lighting
with a Match.” If match lighting is successful, the problem
lies in the ignition system.
MAINTAINING THE PUSH BUTTON
IGNITION SYSTEM (Q
®
1000 & Q
®
2000)
• Check that both the white (1) and black (2) ignition
wires are attached properly.
• Verify that the igniter button pushes in, clicks and
returns to the out position.
MAINTAINING THE ELECTRONIC
IGNITION SYSTEM (Q
®
1200 & Q
®
2200)
• Verify that the AAA battery (alkaline only) is in good
condition and is installed correctly (3). Some batteries
have a plastic protective wrap around them. This
plastic must be removed before installing battery. Do
not confuse this plastic with the battery label.
• Make sure that both igniter wires are properly attached
to the igniter module. Black wire to black terminal (4),
white wire to white terminal (5).
• Make sure the electronic igniter button is working by
listening for clicking and looking for sparks at burner.
If the electronic ignition system still fails to ignite,
contact the Customer Service Representative in your
area using the contact information on our web site.
Log onto www.weber.com
®
.
1
2
3
5
4
To obtain replacement
disposable drip pans and
cooking grates,contact
thelocal retailerin
your areaor log onto
www.weber.com
®
. If you need
furtherassistance, contact
your Customer Service
Representative.
 previous next