Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Buy Weber Grill Parts. It couldn't be easier. Find your Weber parts here.
14 WWW.WEBER.COM
®
BURNER IGNITION & USAGE
Summary lighting instructions are on
the right fold-out table (Q
®
1200, Q
®
2000,
Q
®
2200).
METHODS OF BURNER
IGNITION
There are two ways to ignite
the burner. The first is by
using the ignition system built
into your grill. The second is
with a match.
Next are the steps for igniting
your grill using the ignition
system. On the following page
are steps for igniting your grill
with a match.
BURNER IGNITION
A) Open the grill lid (1).
m DANGER
Failure to open the lid before igniting the
grill’s burner, or not waiting five minutes
to allow the gas to clear if the grill does
not light, may result in an explosive
flare-up which can cause serious bodily
injury or death.
B) Unfold the side tables(2) (Q
®
1200, Q
®
2000,
Q
®
2200).
C) Make sure the burner control knob is turned to the off
( ) position(3). Check by pushing burner control knob
in and turning it clockwise until it stops.
D) Confirm that the cylinder is properly installed. Refer to
“INSTALLING THE LP CYLINDER.”
E) Push burner control knob in and turn it
counterclockwise to start/high ( ) position (4).
F1) Push the red igniter button several times, so it clicks
each time (5) (Q
®
1000, Q
®
2000).
OR
F2) Push and hold in the electronic igniter button (6)
(Q
®
1200, Q
®
2200). You will hear the igniter clicking.
G) Check that the burner is lit by looking through the
cooking grates. You should see a flame.
m WARNING: Do not lean over the open
grill while igniting.
m WARNING: If burner fails to ignite
within five seconds, stop, turn the
burner control knob to off and wait
five minutes to allow the gas to clear
before you try again or light with a
match.
TO EXTINGUISH BURNER
Push burner control knob in and turn it clockwise to the off
( ) position.
m CAUTION: Do not fold in side tables
until grill is cold (Q
®
1200, Q
®
2000,
Q
®
2200).
Some batteries have a plastic
protective wrap around them.
This plastic must be removed
before you attempt to ignite
your grill. Do not confuse this
plastic with the battery label.
2
1
3
4
6
5