Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Buy Weber Grill Parts. It couldn't be easier. Find your Weber parts here.
26
ROTISSERIE TROUBLESHOOTING
PROBLEM CHECK CURE
Burner does not light.
Did you hold the burner control knob
down and hold down for 20 seconds
until after burner ignited?
Try to relight burner by holding burner control knob down and continue
holding down until 20 seconds after burner has ignited.
Did you wait to see the entire ceramic
surface become alight before counting
20 seconds?
When relighting burner by holding burner control knob down, wait to see
the entire ceramic surface become alight before counting 20 seconds?
Is the igniter sparking? Replace battery in igniter button module. Reseat burner ring.
Burners do not light. -or- Burners
have a small fl ickering fl ame in
the HIGH position. -or-
Barbecue temperature only
reaches 250˚ to 300˚ in the HIGH
position.
The excess fl ow safety device, which
is part of the barbecue to cylinder
connection, may have activated.
To reset the excess fl ow safety device turn all burner control knobs
and the cylinder valve OFF. Disconnect the regulator from the cylinder.
Turn burner control knobs to HIGH. Wait at least 1 minute. Turn burner
control knobs OFF. Reconnect the regulator to the cylinder. Turn
cylinder valve on slowly. Refer to “Lighting Instructions”.
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact
information on our web site. Log onto www.weber.com
®
.