Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Buy Weber Grill Parts. It couldn't be easier. Find your Weber parts here.
D-11
Operating Instructions
Lighting the Rotisserie Burner
ƽATTENTION: READ BEFORE
LIGHTING ROTISSERIE BURNER
After a period of non-use, before lighting the Rotis-
serie Burner, a few seconds must pass for the gas
supply line to fill.
When holding the ignition button you will see a flash
of flames moving from right to left across the Rotis-
serie Burner surface, the Rotisserie Burner is not lit
until the entire ceramic surface is aflame.
At this point, start a count of 20 seconds before
releasing the Rotisserie Burner control knob.
The Rotisserie Burner surface will glow red once the
burner is fully ignited.
ƽCAUTION: The Rotisserie Burner flame may be
difficult to see on a bright sunny day.
ƽWARNING: Check hose before each use of grill for
nicks, cracking, abrasions or cuts. If the hose is
found to be damaged in any way, do not use the
grill. Replace using only a Weber
®
authorized re-
placement hose. Contact the Customer Service
Representative in your region using the contact
information sheet provided with your manual.
1) Open the lid.
2) Remove the warming rack and the cooking grates
from the cookbox.
ƽDANGER:
Failure to open the lid while igniting the grill, or not
waiting 5 minutes to allow the gas to clear if the grill
does not light, may result in an explosive flare-up
which can cause serious bodily injury or death.
3) Make sure all burner control knobs are turned OFF.
(Push control knob down and turn clockwise to ensure
that it is in the OFF position.)
ƽWARNING: The burner control knobs must be in the
OFF position before turning on the liquid propane
cylinder tank valve. If they are not in the OFF posi-
tion, when you turn on the LP cylinder valve, the
“excess gas flow control” feature will activate,
limiting the flow of gas from the LP cylinder. If this
should occur, turn OFF the LP cylinder valve and
burner control knobs. Then start over.
1
8
3
4
6
3
5,7
1
3
3
4
6
8
5,7
*The grill illustrated may have slight differences than the
model purchased.
ƽDANGER:
When the “excess gas flow control” feature is acti-
vated, a small amount of gas is still flowing to the
burners. After turning OFF the cylinder and burner
control knobs, wait at least 5 minutes for the gas to
clear before attempting to light the grill. Failure to do
so may result in an explosive flare-up, which can
cause serious bodily injury or death.
4) Turn the cylinder on by turning the cylinder valve
counterclockwise.