Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Buy Weber Grill Parts. It couldn't be easier. Find your Weber parts here.
16
(a)
(a)
(b)
Figure 13
Figure 14
Step 12
Add bowl panel, tool holders and CharBin
Storage Container
You will need: bowl panel, three tool holders and
CharBin Storage Container.
Remove protective plastic covering from bowl panel.
Slide the ends of bowl panel under bowl mounting
brackets so the ends rest on tabs inside frame. Set the
panel in place on top of the frame brace. Figure 13.
Hook the tool holders over the frame rail. There is a
cut-out on the right side of the front panel to
accommodate the tool holders. Figure 13.
Note: Before sliding the CharBin into place check that
the Cooking grate holder is sitting loosely on the frame
brace and is conforming to the frame brace. Figure 14 a.
If it is tight or stuck over the edge of the frame brace,
Figure 14 b, reposition as in Figure 14 a.
If the Cooking grate holder is not correctly positioned, it
could allow the CharBin to slide through the frame.
Slide CharBin down into the top frame with the deep
end toward the rear. Figure 14.
Tool holders
CharBin
Inside of
Frame Brace
Cooking grate
holder
Bowl panel
Tab