Weber 3200 LP Gas Grill User Manual


 
6
SET LP FUEL SCALE
You will need: LP tank (empty).
Note - For accuracy, the fuel scale must be set with an
empty tank.
We utilize various LP tank manufacturers. Some of the
tanks we receive have differing top collar assemblies.
(The top collar is the metal protective ring around the
valve.) One series of tanks mounts with the valve facing
front. The other tanks mount with the valve facing away
from the fuel scale. These types of tanks are illustrated in
Figure 9.
Loosen the tank lock wing nut. Tighten so the lock is held
up out of the way. Figure 9 (a). Lift and hook the tank onto
the fuel scale. With an empty LP tank, adjust the fuel scale
setting to E with scale setting (top) wing nut. Figure 9 (b).
CAUTION: Do not remove adjustment wing nut from
tank scale.
After adjusting tank scale, push tank down a couple of
times to check that the tank scale is set on “E”.
F
E
(a)
Scale setting
wing nut
Figure 9
F
E
(b)
FILL LP TANK
To fill, take the LP tank and filler adapter to an RV center,
or look up gas-propane in the phone book for other
sources of LP gas.
WARNING: We recommend that your LP tank be filled
at an authorized LP gas dealer by a qualified
attendant, who fills the tank by weight.
IMPROPER FILLING IS DANGEROUS.
Tell your LP dealer that this is a new LP tank. The air
must be removed from a new LP tank before the initial
filling. Your LP tank dealer is equipped to do this.
CAUTION: If you exchange your LP tank, make sure
you get a similar tank in return.Your LP tank is
equipped with a Type II, CGA #810 quick-disconnect
valve. Other LP tanks are not compatible with your
barbecue connection.
The LP tank must be installed, transported and stored in
an upright position. LP tank should not be dropped or
handled roughly.
Never store or transport the LP tank where temperatures
can reach 125° Fahrenheit (too hot to hold by hand – for
example: do not leave the LP tank in a car on a hot day).
For full instructions on safe handling of LP tanks, see
Section "General Tank Information”.