Weber 3200 Gas Grill User Manual


  Open as PDF
of 40
 
23
Step 26
Complete accessory installation
You will need: work table, accessory rack, Warm-Up
Basket, warming rack, thermometer, three tubing plugs
and a hammer.
Insert one end of the Weber Warm-Up Basket into the hole
in the right end of the lid and the other end into the slot in
the left end of the lid. Figure 35 (a).
Set the work table onto the left side rails. Figure 35 (b).
Set the accessory rack between the two frame connectors.
Figure 35 (c).
Set the warming rack into the slots at the rear of the
cooking box. Figure 35 (d).
Insert the thermometer into its holder. Figure 35 (e).
Insert tubing plugs into the ends of the frame. To fully seat
the plugs, you may have to tap them lightly with a hammer.
Figure 35 (f).
Figure 35
(a)
(d)
(e)
(f)
(b)
(c)
Position slide bar assembly on the outside of the caster
frame. Put a nylon washer on each 1 3/4 inch screw, insert
screws through frame and slide bar assembly and add
nylon washers and hex nuts. Tighten nuts using a
screwdriver and pliers. Figure 33.
Figure 33
View from front
of barbecue
Notch to the front
Slide bar
To lower table: Pull support rod up to disengage slide lock,
and lower table. To raise table, lift table up and engage slide
in locked position. Figure 34.
View from rear
of barbecue
Support rod
Locked position
Unlocked position
Figure 34
Slide
ƽCAUTION: To keep the barbecue stationary, the tabs
on the locking casters should be in the down position.
 previous next