Weber 1200 Gas Grill User Manual


  Open as PDF
of 36
 
23
Lighting
Summary lighting instructions are on the control panel.
Crossover Ignition System
Note - The Crossover Ignition System ignites the Front
burner with a spark from the igniter electrode inside the
Gas Catcher Ignition Chamber. You generate the energy
for the spark by pushing the Crossover Ignition Button until
it clicks.
ƽWARNING: Check hose before each use of
barbecue for nicks, cracking, abrasions or cuts. If the
hose is found to be damaged in any way, do not use
the barbecue. Replace the manifold assembly, which
includes the gas hose. Call your dealer for the
necessary parts.
6
8
5
2
7
4
3
1
Figure 1
Crossover Ignition System
OPERATING INSTRUCTIONS
ƽ DANGER
Failure to open lid while igniting the
barbecue, or not waiting 5 minutes to
allow the gas to clear if the barbecue
does not light, may result in an explosive
flame-up which can cause serious bodily
injury or death.
ƽWARNING: The burner control knobs must be in the
OFF position before turning on the LP tank valve. If
they are not in the OFF position, when you turn on the
LP tank valve, the excess flow control will activate,
limiting the flow of gas from the LP tank. If this should
occur, turn OFF the LP tank valve and burner control
knobs and start over.
4) Turn the tank on by turning the tank valve
counterclockwise.
ƽWARNING: Do not lean over open barbecue. Keep
your face and body at least one foot away from the
matchlight hole when lighting the barbecue.
5) Push Front burner control knob down and turn to
START/HI.
6) Push the Crossover Ignition Button several times, so it
clicks each time.
7) Check that the burner is lit through the matchlight
hole on the front of the cooking box.
ƽWARNING: If the burner does not light, turn the
Front burner control knob to OFF and wait 5 minutes
to let the gas clear before you try again or try to light
with a match.
8) After the FRONT burner is lit you can turn on the other
burners.
Note - Always light the FRONT burner first. The other
burners ignite from the FRONT burner.
To Extinguish
Turn gas supply OFF at the source, then push down
and turn each burner control knob clockwise to OFF.
ƽ DANGER
When the excess flow control is
activated, a small amount of gas is still
flowing to the burners. After turning OFF
the tank and burner control knobs, wait
at least 5 minutes for the gas to clear
before attempting to light the barbecue.
Failure to do so may result in an
explosive flame-up which can cause
serious bodily injury or death.
1) Open the lid. Figure 1.
2) Check that the fuel scale reads more than “E”.
Note - E = empty; F = full.
3) Make sure all burner control knobs are OFF. (Push
each burner control knob down and turn clockwise.)
 previous next