Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Buy Weber Grill Parts. It couldn't be easier. Find your Weber parts here.
22
Step 23
Complete accessory installation
You will need: Warm-Up Basket, warming rack, work
table,two accessory trays, three tubing plugs, thermometer
and a hammer.
Insert one end of the Weber Warm-Up Basket into the hole
in the right end of the lid and the other end into the slot in
the left end of the lid. Figure 32 (a).
Set the warming rack into the slots at the rear of the
cooking box. Figure 32 (b).
Set the work table onto the left side rails. Figure 32 (c).
Set the accessory trays in place between the two frame
connectors. Figure 32 (d).
Insert the thermometer into its holder. Figure 32 (e).
Insert the tubing plugs into the ends of the frame. To fully
seat the plugs, you may have to tap them lightly with a
hammer. Figure 32 (f).
Figure 32
(a)
(b)
(c)
(d)
(e)
(f)
Position slide bar assembly on the outside of the caster
frame. Put a nylon washer on each 1 3/4 inch screw, insert
screws through frame and slide bar assembly and add
nylon washers and hex nuts. Tighten nuts using a
screwdriver and pliers. Figure 30.
Figure 30
View from front
of barbecue
Notch to the front
Slide bar
To lower table: Pull support rod up to disengage slide lock,
and lower table. To raise table, lift table up and engage slide
in locked position. Figure 31.
View from rear
of barbecue
Support rod
Locked position
Unlocked position
Figure 31
Slide
ƽCAUTION: To keep the barbecue stationary, the tabs
on the locking casters should be in the down position.