Viking VGIQ410E Gas Grill User Manual


 
BURNER ADJUSTMENT
Each burner is tested and adjusted at the factory prior to shipment; however, variations in the local gas supply may
make it necessary to adjust the burners. The flames of the burners (except the rotisserie infrared burner) should be visually
checked and compared with Fig. 1, Fig. 2, and Fig. 3.
Flames should be blue and stable with no yellow tips, excessive noise or lifting. If any of these conditions exist, check
if the air shutter or burner ports are blocked by dirt, debris, spider webs, etc. With a proper flame height, adjust the air shutter
to obtain a blue flame with no yellow tipping that sits on the burner at the burner ports. The air shutter is locked in place by a
set screw which must be loosened prior to lighting the burner for adjustments.
To accessthe air shutter on the grill burners and smoker burner, remove the valve panel. To accessthe air shutter on
the side burners, remove the grates, burner bowls, and grate support. With a screw driver, loosen the lock-screw on the face
of the air shutter. Light the burner and adjust according to the directions below.
1. If the flame isyellow, turn the air shutter counter clockwise to allow more air to the burner.
2. If the flame is noisy and lifting away from the burner, turn the air shutter clockwise to reduce the amount of air to
the burner.
Once adjusted, turn the burner off, tighten the set screw on the air shutter, replace the valve panel for the grill burners and the
grate support, burner bowls, and grates for the side burners.
To ensure proper installation of the grill burners, side burners, and smoker burner:
1. Slide opening in air shutters over the orifice located in the front of the grill.
2. For the smoker burner, secure back of the burner by placing over screw slot on rear of grill and replacing screw.
Fig. 1
GRILL BURNER
1/2" l
(1.3 cm)_
3/8"
(.95 cm)
Orifice
Air
Shutter ,,
3/8" (.95 cm)
SMOKER BURNER
13