Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Page 12
Main and Smoker Burners:
1. Raise hood/
lid.
2. Light only one burner at a time.
3. Always turn control knob to the “Lite” position and
immediately press and hold the ignition switch. The
burner will light within 4 -10 seconds.
4. Release ignition switch after burner ignites. Look
for the flame to check that it is lit. For the smoker
burner, pull drawer open to see the flame.
5. Repeat procedures until desired number of burners
are lit.
6. Adjust control knobs to the suggested preheat
flame setting. Refer to the Grill Cooking Chart
Pages 16 and 17.
SECTION 3: USING YOUR CHAR GLO
®
BARBECUE
Infrared Rotisserie Burner:
1. Raise hood
/
lid.
2. IMPORTANT NOTE: Make sure the control
knob is set to the “LITE” position when lighting
the infrared burner. Confirm that the burner
has lit within 30 - 45 seconds. The flame will be
blue initially.
3. Allow the burner to operate on "HI" until it
begins to glow orange/red (typically 2-3 minutes)
before adjusting the control knob to the desired
flame setting.
3. Adjust control knob to the suggested flame
setting. Refer to the Rotisserie Cooking Chart
Page 20.
Side Burner/s:
1. Remove stainless steel cover; set aside.
2. Turn control knob to the “Lite” and immediately
press ignition switch. The
burner
will light
within 4 -10 seconds.
3. Adjust control knob to the desired flame setting.
LIGHTING INSTRUCTIONS WITH AUTOMATIC IGNITION
– Read Before Lighting –