Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
WWW.WEbER.com
®
31
SEAR STATIoN
®
TRoUbLESHooTING
PRobLEm cHEcK SoLUTIoN
Burners burn with a yellow or orange flame, in
conjunction with the smell of gas. (This is normal for
the burner lighting tube.)
Sear Station
®
burner does not light.
Inspect spider/insect screens for possible obstructions.
(Blockage of holes.)
Clean spider/insect screens (refer to “ANNUAL
MAINTENANCE”).
Did you ignite the two adjacent main burners? (Refer to
“SEAR STATION
®
IGNITION & USAGE” instructions for
safe lighting procedure.)
Verify adjacent main burner ignition by visual inspection
of a flame.
m WARNING: If ignition does not occur
in five seconds, turn burner control
OFF, wait five minutes to let the gas
clear before you try again.
Does Burner light with a match? If you can light Burner with a match, then check the
Crossover
®
Channel on the sear burner (refer to
“MAINTENANCE” for burner removal and cleaning
procedure).
Does the igniter work? Do you see a spark when you
repeatedly use the snap igniter?
Try manually lighting the burner (refer to “SEAR
STATION
®
IGNITION & USAGE”). Call Customer Service.
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our
web site. Log onto www.weber.com
®
.
RoTISSERIE TRoUbLESHooTING
GRILL oUT™ HANDLE LIGHT TRoUbLESHooTING
PRobLEm cHEcK SoLUTIoN
Weber Grill Out™ Handle Light does not light. Are the batteries old? Replace batteries.
Are the batteries installed correctly? Refer to assembly illustration.
Is the lid in the up position with the power button ON? Light will activate when lid is open.
Is the Weber
®
Grill Out™ Handle Light activated? Press the power button.
Is the Weber
®
Grill Out™ Handle Light positioned
correctly on the handle?
Adjust position. Refer to assembly illustration.
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our
web site. Log onto www.weber.com
®
.
PRobLEm cHEcK SoLUTIoN
Rotisserie burner does not light. Did you hold the burner control knob in and hold in for 20
seconds until after burner ignited?
Try to relight burner by holding burner control knob in
and continue holding in until 20 seconds after burner has
ignited.
Did you wait to see the entire ceramic surface become
alight before counting 20 seconds?
When relighting burner by holding burner control knob
in, wait to see the entire ceramic surface become alight
before counting 20 seconds.
Did you repeatedly use the snap ignition until the burner
ignited?
After waiting five minutes for gas to clear, try repeatedly
to use the snap igniter until the burner ignites. Refer to
“ROTISSERIE BURNER IGNITION & USAGE”.
Does the igniter work? Do you see a spark when you
repeatedly use the snap igniter?
Try manually lighting the burner. Refer to “ROTISSERIE
BURNER MANUAL IGNITION”. Call Customer Service.
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our
web site. Log onto www.weber.com
®
.