Southern Pride SC-200 Smoker User Manual


 
SC-200-SM DIGITAL CONTROL OPERATING INSTRUCTIONS
To Program a menu:
The menu consists of a cook temperature, cook time, hold temperature, and CHIPS which turns
the smoker on or off for the menu.
1. Control must be in the “IDLE” mode. If the control
is “OFF” a press of any button will bring the control
back to “IDLE
2. PRESS the cook temp button, (the actual cook temperature will appear
in the display): PRESS the up/down buttons to obtain the desired cook
temperature.
3. PRESS the cook time button, (tinE 1 will appear in
the display): PRESS the up/down buttons to obtain the
desired cook time.
4. PRESS the hold temp button, (HtEnP will appear in the LED display):
PRESS the up/down buttons to obtain the desired hold temp. If a hold temp
is not desired: PRESS the down button until “OFF” is displayed in the LED.
Programming the menu is complete:
5. To start the menu, PRESS the start/stop button one time. “CHIPS” will
appear in the LED display. Two actions are possible, a touch to the up button
will start the menu with the wood chip smoker “ON” or a touch to the down
button will start the menu with the wood chip smoker “OFF”. The control
will begin the menu.
6. To pause the menu, press the start/stop button; to resume the menu, press the start,/stop again.
7. To cancel or stop a menu, press and hold the start/stop button until “IDLE” shows in the LED.
7
When cook cycle is complete:
8. Two actions are possible after the cook time expires. If a hold temperature
was programmed into the menu, then the control will sound an audible alarm
momentarily, and “Hold” will appear in the LED display. The length of time
the control has been in the hold mode, and the word “Hold” will be displayed
alternately in the LED display. The control will maintain the hold temperature
until the start/stop button is depressed to “END” the menu, and bring the
control to the “IDLE” mode.
If the hold temperature was programmed to “OFF” then “END” will be
displayed on the LED, and an audible alarm will sound continuously until the
start/stop button is depressed, to end the menu, and bring the control to the
IDLE” mode.