Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
7
W415-0377 / 03.04.03
NAILING
TAB
1) Attach the nailing tabs to the corner posts
using the 2 sheet metal screws
supplied. Secure through the
centre of the top and bottom
slots in the nailing tab and then
through the existing holes in
the corner posts.
If there are no existing holes,
follow these instructions:
Position the nailing tab so that
the front face is offset with the
front edge of the corner post
(approx. ½"). Centre the nailing tab
vertically on the corner post.
Figure 12 a.
Drill through the centre of the top and bottom slots in
the nailing tab. Secure using the two sheet metal screws
supplied. This allows the nailing tab to slide back and
forth for desired framing. Figure 12 b.
2) To determine the final location of the nailing tab you
must first determine the thickness of your finishing mate-
rial (i.e. drywall). This will determine the dimension from
the front edge of the corner post to the nailing tab. Once
the nailing tab is in the desired location, drill through the
centre hole of the nailing tab. Secure with a sheet metal
screw*. Figure 12 c.
* Additional set screws may be installed.
FIGURE11
Combustible materials may be installed flush with the front
of the fireplace but must not cover any of the black face-
areas of the fireplace. Non-combustible material (brick,
stone or ceramic tile) may protrude in these areas.
Combustible mantle clearance can vary according to the
mantle depth. Use the graph to help evaluate the clear-
ance needed. Figures 11 a & b.
FIGURE 13a
FIGURE 13b
FIGURES 12a-c
TOP SLOT
FINISHING
MATERIAL
CORNER
POST
NAILING
TAB
A
B
C
CENTRE
HOLE
NAILING TAB INSTALLATION
MANTLE CLEARANCES