Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
7
Install Heat Shield
toward left side
(tank side) of Body.
Note orientation of venturi
tubes to Heat Shield.
2
3
4
1
STEP 4 - Attach Flavor Activator Pins, Grease Cup Hanger, Burner & Heat Shield
Follow the steps in order below. Refer to the step numbers below and beside the images.
1. Assemble 2 flavor activator Mounting Studs and two Fiber Washers to the bowl using 2 M6 nuts.
2. Insert Grease Cup Hanger into bowl.
3. Insert Burner Venturi tubes down through holes in bottom of grill bowl toward front of grill. Also
insert igniter wire through hole in bottom of bowl. From underside of bowl, insert 2 ST 4.0 x 10mm
screws into burner mounting holes and tighten.
4. Thread grease cup holder through center hole of heat shield and secure heat shield to bottom of
bowl as shown using 1 ST 4.0 x 10mm Screw. The shield will later be secured to the cylinder slide
bracket on the cart.
Inside of Bowl
Mounting
Stud
M6
2 pcs
Nut
M6
2 pcs
Screw
ST 4.0 x 10mm
3 pcs
Grease Cup Hanger
Fiber
Washer
2 pcs