Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Installing Manual Lighting Stick
1.
Attach the Manual Lighting Stick to the Left
Bowl Support Bracket as shown in Fig. 11.
Align the hole at the end of Manual Lighting
Stick Wire with the threaded hole on the Left
Bowl Support Bracket. Tighten securely using
the M4x8mm Phillips Head Screw.
Figure 11
OUTSIDE BOWL
PANEL-LEFT
Installing Side Shelf and Cart Side Handle
1. Remove the white protective film from the
stainless steel Side Shelf,
2. Enlisting the aid of an assistant, attach Side
Shelf to left side of grill. Align the holes on Side
Shelf with the threaded holes on left Outside Bowl
Panel. Tighten securely using 4 of the
1/4"x3/4" Phillips Head Screws provided.
See Fig. 12.
3. Enlisting the aid of an assistant, attach Cart Side
Handle to right side of grill. Align the holes on Cart
Side Handle with the threaded holes on
right Outside Bowl Panel. Tighten securely using
4 of the 1/4"x3/4" Flat Head Screws provided. See
Fig. 12.
M4x8mm PHILLIPS
HEAD SCREW
I _ MANUAL LIGHTING
STICK
Figure 12
SIDE SHELF-LEFT
GRILL HEAD
OUTSIDE BOWL
PANEL-RIGHT
CART SIDE
HANDLE
Ignitor Battery Installation - See Fig. 13
1, Unscrew the Ignitor Cap located on the grill
Control Panel and remove the Contact and
Spring from each Ignitor Slot,
2. Place each supplied AA battery into each
Ignitor Slot. Be sure to place the positive pole
facing toward you. See Fig. 13
3. Place the Spring over the AA battery, then
place the Contact on top of the Spring. Screw
the Ignitor Cap back onto the grill Control
Panel.
4. Remove any protective film from outside and
inside of Grill Head.
IMPORTANT: Before use of this grill please
refer to Cleaning Exterior Stainless Steel
Surfaces found on page 21 of this Owner's
Manual.
Figure 13
.j"
IGNITOR CAP
CONTACT
14
IGNITOR SLOT
BATTERY