Kenmore 141 17690 Gas Grill User Manual


  Open as PDF
of 38
 
Installing The Grill Head
1.
Now that you've assembled the grill cart you
can install the pre-assembled Grill Head. See
Fig. 9. If you haven't already done so, open
the Grill Lid and remove the packed
components. Lock the casters. Even with the
components removed, the next step requires 2
people.
2.
With an assistant, carefully lift and position
the Grill Head onto the grill cart. Align the 6
holes of the Bowl Side Panel to the threaded
holes on the Cart Side Panel Bracket. Secure
firmly by using 6 of the l/4"x30mm Phillips
Head Screws provided. BE CAREFUL NOT
TO PINCH FINGERS WHEN LOWERING
HEAD ONTO CART
3,
Open the front Doors of cabinet. Remove
fastening band from Fuel Gauge Display Wire
Plug "A" that is behind the Heat Shield of the
Control Panel.
4. Place the Wire Plug "A" through the slot in
side of Right Cart Side Panel as shown in
Fig. 10.
Figure 9
CART SIDE
PANEL
BRACKET
Figure 10 (LP gas model only)
GRILL HEAD
BOWL SIDE
PANEL
PRE-ASSEMBLED
REGULATOR
(LP gas modelonly)
PANEL-RIGHT
CONTROLPANEL
SLOT FOR WIRE
PLUG "A"
FUEL GAUGE DISPLAY
( LP gas model only)
13
 previous next