Kenmore 141 16690 Gas Grill User Manual


 
Fuel Gauge Display Installation.
IMPORTANT: Before installingbatteries be sure the
gas tank is not mounted inthe tank pull-out tray.
1, Open the frontDoorsof Cabinet. Pullout the LPG Tank
Pull-out Tray. Connect the Wire Plug "A" from Fuel
Gauge Displaywiththe Wire Plug"B"from rear ofTank
Pull-outTray. Unscrew 1/4"x 1/2" Phillipshead Screw
from Rear Panel and install Wire Fastener to Rear
Panel. Tighten securely using the same screw. See
Fig.16a
2. From the underside of the Control Panel, unscrew the
Fuel Gauge Display Cover on the Fuel Gauge Display
Box. See Fig.16b
3. Carefully remove the battery box from the back of the
Fuel Gauge Display Box and insert two "AAA" batter-
ies (provided). Be sure to follow correct polaritywhen
inserting batteries.
4. Return the Battery Box with electric wire into the Fuel
Gauge Display Box.
5. Screw the Fuel Gauge Display Cover onto the Fuel
Gauge Display Box.
Figure 16a
TANK PULLOUT
TRAY
_REAR PANEL
CART SIDE
PANEL-RIGHT
_WIRE
FASTENER
WIRE PLUG "A"
FUELGAUGE
DISPLAY
WIRE PLUG "A"
Fuel Gauge Display Operating - See Fig. 16c
Press the"CHECK" buttonto operateFuelGauge Display.
NOTE: Tank must be positioned in tray for Fuel
Gauge Display check
1.Fuel Display: Indicates gas tank fill level
2. Fuel Warning Display: When the gas tank fill level is
on the last row a warning signal will sound for approxi-
mately 3 seconds to warn you that the tank volume is
near empty.
3.Battery Warning Display: A low battery warning light
will illuminate when the battery voltage drops to a low
level. Replace the batteries.
Figure 16b
FUEL GAUGE
DISPLAY COVER
DISPLAY BOX
WIRE
BATTERY BOX
IMPORTANT: When the gas tank is removed from
the tank pull-out tray, thefuel gauge display will not
operate,
16
Figure 16c
FUEL -- --- /
DISPLAY CHECK
BATTERY FUEL
WARNING
WARNING
DISPLAY
DISPLAY
CHECK
BUTTON