Jenn-Air CG106 Gas Grill User Manual


 
The grill consists of two black grill grates and a grill burner. Note for CG206 and
CVG316: only install the grill on the left side of your cooktop. Note CG205 Owners:
An optional grill accessory, AG150, may be used on the left side only.
To Install Grill Module
1. Before installing grill components, be certain control knobs are in the OFF position.
2. Position the grill burner with mixer tube openings toward the orifices. Slide the burner
toward the orifices until igniter is in between front and rear grill sections. Lower into
place until side openings are resting on the burner support pins.
3. Place the grill grates on the top of the cooktop.
Note: Before using the grill for the first time, heat the E-ven HeatTM grill burner
to remove the protective shipping coating. Heat the grill on Hi for 10 minutes
and use the vent system to remove any additional smoke during cooling.
When the E-ven Heat grill burner is a dull black, it is ready to use,
To Remove Grill Module
1. Remove grill components once they are cool. Be sure control knobs are in the OFF
position.
2. Remove grill grates.
3. Remove grill burner.
12