Jackson JG4 Gas Grill User Manual


 
4
CLEARANCES
1. The appliance must have a minimum
horizontal clearance from sides and
back of unit to adjacent vertical
combustible construction below and
extending above the top of the unit 36
inches from sides and 36 inches from
back of unit.
2. Do not locate this appliance under any
overhead unprotected combustible
construction.
3. This appliance is for outdoor use
only. Do not operate in garage,
shed, balcony or other such enclosed
areas.
4. Do not restrict or obstruct the flow of
combustible and ventilation air to the
appliance.
5. Keep the area surrounding the
appliance free of combustible
materials, gasoline and all flammable
liquids and vapours.
6. This appliance is not intended to be
installed in or on recreational vehicles
and/or boats.
LP GAS CYLINDER PLACEMENT
Cylinders must be installed according to
assembly instructions. Install the gas
cylinder into the tank hole inside of the
Jackson Pedestal.
LP GAS CYLINDER
QCC-1 Quick Closing Coupling
Your grill is designed to be used with an
LP gas cylinder equipped with the new
QCC-1 Quick Closing Coupling system.
The QCC-1 system incorporates new
safety features required by the Canadian
Standards Steering Committee and the
American National Standards Institute
(ANSI).
Gas will not flow until a positive
connection has been made.
A thermal element will shut off flow of
gas between 240 degrees and 300
degrees F. When activated, a flow-
limiting device will limit the flow of gas
to 10 cubic feet per hour.
The LP Gas Cylinder is not included
with the Gas Grill. Be sure to purchase
one with the QCC valve. This valve is
recognized by the external threads on the
inlet port of the valve. QCC equipped
cylinders are available from your gas grill
dealer. Any attempt to connect the
regulator, by use of adapters or any
other means, to any other valve could
result in damage or fire, and may
negate the important safety features
designed into the QCC-1 system.
SPECIFICATIONS
1. All LP gas cylinders used with this
appliance must be constructed and
marked with the specifications for LP
cylinders in accordance with the
Canadian Transport Commission (CTC)