GE Monogram 27 Gas Grill User Manual


 
17
The Rotisserie System
Stainless Steel Outdoor Cooking Center
Assembly
On 24models the motor is mounted by sliding
it down into place in the metal channel attached
to the right side of the grill. The skewer is
connected to the motor assembly by placing
the pointed end through the motor access hole
in the grill and into the motor. The left side of
the skewer rests in the grill groove.
On 27models the motor is mounted to a metal
channel which attaches to the left side of the
grill and is tightened into place with a thumb
screw. Ensure that the motor is straight prior to
tightening the thumb screw.
The rotisserie motor on 36and 48models is
secured down to a cast rotisserie block with the
black screw-down knob. The rotisserie block is
in turn bolted to the right side panel.
On 36and 48models, the skewer or the
rotisserie is attached to the motor assembly by
placing the pointed end into the motor and
resting the threaded end on the support at the
left side (right side on 27models) of the grill.
With the skewer pushed as far as possible into
the motor, the grooved skewer bushing should
rest on the left side bracket. (It will rest on the
right side on 27models.)
The removable black handle should only be in
place when handling the skewer. Remove the
handle when cooking to allow the lid to close
and avoid melting the handle with heat from
the range-top burners (on some models).
24model rotisserie assembly
36and 48model rotisserie assembly
27model rotisserie assembly
Remove the skewer handle to close the
lid on models with side burners
Remove handle
Side burners