Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Using the Rotisserie & Side Burners
15
ROTISSERIE LIGHTING
Open the lid. Push and turn the control knob for the rotis-
serie counter clockwise to the “HIGH” position.
Wait 5
seconds
. Then press and hold the electronic igniter
button. You’ll hear a snapping sound. If the burner does
not light in 4 seconds, turn the control knob to OFF and
wait 5 minutes before trying again. Once lit, turn the
control knob to the desired setting. (See Fig. 18)
MATCH LIGHTING
If by chance the electronic igniter does not light the
burner
, the burner may be lit with a match. Attach the
match to the match extender, located inside the right
cart door.
Keep your face as far away from the grill surface as possi-
ble and hold a match, attached to the match extender, to
the burner
, then push and turn the control knob counter
clockwise to the “HIGH” position. (See Fig. 19)
NOTE: After the first use the stainless steel around
the burner will darken. This is a normal reaction of
premium stainless steel to heat and is not a defect.
The infrared panel will also darken after initial use.
This is also a normal occurrence.
SIDE BURNER LIGHTING
Push and turn the control knob to the “HIGH” position
and immediately press and hold the electronic igniter
button.
You’ll hear a snapping sound. It may be neces-
sary to hold the electronic starter button for about 4
seconds. If the burner does not light in 4 seconds, turn
the knob to the “OFF” position and wait 5 minutes
before trying again. Repeat above steps to light
remaining burners. (See Fig. 20)
MATCH LIGHTING
If by chance the electronic igniter does not light the
burner
, the burner may be lit with a match.
Attach the
match to the match extender, located inside the right
cart door.
Keep your face as far away from the grill surface as
possible and hold a match, attached to the match
extender
, near the burner ports
, then push and turn the
control knob counter clockwise to the “HIGH” position.
Fig. 18
Fig. 19
Fig. 20
NOTE: Do not operate the main
burners and infrared back burner
at the same time. This can cause
warping of the roll top grill hood.
!