Dimplex BF39ST/DX Fire Pit User Manual


 
11
BF33ST, BF33DX, BF39ST, BF39DX, BF45ST, BF45DX
If the fireplace was operating prior to servicing allow at least 10 minutes for light bulbs
and heating elements to cool off to avoid accidental burning of skin.
Disconnect circuit power before attempting any maintenance or cleaning to reduce the
risk of electric shock or damage to persons.
TO REPLACE MAIN ON/OFF SWITCH
1. Open the steel curtains (remove glass doors if applicable).
2. Remove the log grate retaining screws and remove the log grate.
3. Pull the rear edge of the log set forward by grasping the ember bed by the sides
(handle the log set only by the ember bed and not the logs) and pulling firmly
until the rear tab pops out from under the back ledge, then lift out.
4. Remove the light bulb closest to the main on/off switch for easier access.
5. Locate the switch cover plate and remove the mounting screws.
6. Remove the switch cover plate by releasing assembly from the quick connect
connection.
7. Reach hand into the opening and locate the main on/off switch.
8. Depress the retainer clips on the rear of the switch and push the switch out of the
bottom cover.
9. Disconnect the wiring connections noting their original locations.
10. Properly orientate the new switch and connect all of the wiring connections.
11. Reassemble in the reverse order as above.
NOTE: To replace the log set insert the front edge, pushing back down until the rear
tab snaps under the back ledge and the logs are resting against the mirror.