Desa VM42E(B Fire Pit User Manual


 
108796-01E
18
For more information, visit www.desatech.com
For more information, visit www.desatech.com
CLEANING AND
MAINTENANCE
WARNING: The logs can be hot. Handle only
when cool.
WARNING: Turn off gas and electrical power
before servicing appliance.
WARNING: Installation and repair should be done
by a qualified service person. The appliance should
be inspected before each use and at least annually by
a qualified service person. More frequent cleaning
may be required due to excessive lint from carpeting,
bedding material, pet hair, etc. It is imperative that the
control compartments, burners, and circulating air
system be kept clean.
PILOT AND BURNER
Remove logs and ember material before cleaning burner and
replace when cleaning is complete.
Burner and controls should be cleaned with compressed air to
remove dust, dirt, or lint.
Use a vacuum cleaner or small, soft bristled brush to remove
excess dust, dirt, or lint.
LOGS
If you remove logs for cleaning, refer to log placement informa-
tion on pages 13 and 14 to properly replace logs.
Use a vacuum cleaner to remove any carbon buildup on logs.
Replace log(s) if broken. See Replacement Parts, page 19.
Replace ember material periodically as needed. See Replace-
ment Parts, page 19.
Pilot Burner
Ignitor/Sensor
INSPECTING BURNERS
Check pilot flame pattern and burner flame patterns often.
PILOT ASSEMBLY
The pilot assembly is factory preset for the proper flame. Alterations
may have occurred during shipping and handling. The pilot is
located on the back right hand side of the burner.
The flame must envelope 1/4" of top of the ignitor/sensor and
grounding stem.
If your pilot assembly does not meet these requirements:
Turn the adjustment screw marked PILOT clockwise to decrease
or counterclockwise to increase the flame to proper size (see
Figure 37, page 17). Do not remove the adjustment screw.
see Troubleshooting, pages 20 and 21
Figure 39 - Correct Pilot Flame Pattern
BURNER FLAME PATTERN
Burner flames will be steady; not lifting or floating. Flames should
go up through the middle of logset. Flames should not "spill" to the
edges of the pan or sides of the logset.
Figure 40 shows a typical flame pattern. If burner flame pattern differs
from that described:
turn appliance off (see To Turn Off Gas to Appliance, page 17)
see Troubleshooting, pages 20 and 21
Figure 40 - Typical Flame Pattern
INSPECTING BURNERS
Pilot Assembly
Burner Flame Pattern
CLEANING AND MAINTENANCE
Pilot and Burner
Logs
Sensing Rod
WARNING: Failure to keep the primary air
opening(s) of the burner(s) clean may result in soot-
ing and property damage.