Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
www.desatech.com
116238-01E30
CLEANING AND
MAINTENANCE
-
GLASS DOOR
door unlatched, removed, cracked
-
-
Glass must be cleaned periodically. During start-up
it is normal for condensation to form on the inside
of the glass causing lint, dust and other airborne
particles to cling to the glass surface. During initial
start-up a slight lm may form on the glass due to
paint curing. The glass should be cleaned several
times with a non-ammonia, nonabrasive household
cleaner and warm water after the rst two weeks of
operation. Thereafter, clean the glass two or three
times during each heating season, depending on the
usage and circumstances present. Refer to Remov-
ing/Replacing Glass Door, page 24 of this manual
when removing glass door for cleaning.
-
(see Replacement Parts
-
If glass has been broken, carefully remove glass
door (see Removing/Replacing Glass Door, page
24). Vacuum all glass pieces with a shop vac.
CAUTION: Do not vacuum if
Use only the tempered glass door replacement
intended for this replace (see Replacement Parts,
page 34 for detail on ordering). No substitutions
may be made. See Removing/Replacing Glass Door,
page 24 for instructions for replacing glass door.
-
• Remove ember material before cleaning burners
and replace when cleaning is complete.
• Burner and controls should be cleaned with
compressed air to remove dust, dirt or lint.
• Use a vacuum cleaner or small, soft bristled
brush to remove excess dust, dirt or lint.
LOGS
• If you remove logs for cleaning, refer to Install-
ing Lava Rock and Glowing Embers, page 25,
to properly replace logs.
• Use a vacuum cleaner to remove any carbon
buildup on logs.
• Replace log(s) if broken. See Replacement
Parts on page 34.
• Replace ember material periodically as needed.
See Replacement Parts on page 34.