Desa (V)KC36PE SERIES, (V)KC36NE SERIES Outdoor Fireplace User Manual


  Open as PDF
of 40
 
www.desatech.com
116238-01E 29
Figure 45 - Typical Flame Pattern
OpTIONAL REMOTE
OpERATION
Note:TheWRCreceiverandhand-heldre-
motecontrolkitmustbepurchasedseparately
(seeAccessories,page35).Followinstallation
instructionsonpage26.
1. TurnequipmentshutoffvalvetoONposi-
tion.Youcannowturntheburneronandoff
withthehand-heldremotecontrolunit.
IMPORTANT:BesuretopresstheON/OFF
buttonsonthehand-heldremotecontrol
unitforupto3secondstoassureproper
operation.
2. Press the ON/OFF buttonto turnthe
burneronandoff.
OpERATING OpTIONAL

Locatetheblowercontrolsbyopeningthelower
louverpanelonthereplace.Blowercontrols
arelocatedontheleftsideoftheswitchbracket
totherightjustinsidethelouverpanel.
TheBKmanualblowerandtheBKTthermo-
statically-controlledblowerhaveanONsetting
andanOFFsetting.Theblowerwillonlyrun
whentheswitchisintheONposition.Inthe
OFFposition,theblowerwillnotoperate.
  Ifyou areusingBKT
blowerwithoptionalthermostat(wallmounted
orremotecontrol)forthereplace,yourre-
placeandblowerwillnotturnonandoffatthe
sametime.Thereplacemayrunforseveral
minutesbeforetheblowerturnson.Afterthe
heatermodulatestothepilotposition,theblow-
erwillcontinuetorun.Theblowerwillshutoff
afterthereboxtemperaturedecreases.
Theblowerhelps distribute heated airfrom
thereplace.Periodicallycheckthelouversof
thereboxandremoveanydust,dirtorother
obstructionsthatwillhindertheowofair.
INSPECTING BURNERS
Check pilot ame pattern and burner ame pat-
terns often.

The pilot assembly is factory preset for the proper
ame. Alterations may have occurred during ship-
ping and handling. The pilot is located on the left
hand side of the burner.
OPERATING FIREPLACE
Continued
Pilot
Burner
Ignitor/
Sensor
Figure 44 - Correct Pilot Flame Pattern
Sensing
Rod
The ame must envelope 1/4" of top of the ignitor/
sensor and grounding stem.
If your pilot assembly does not meet these re-
quirements:
• Turn the adjustment screw marked PILOT
clockwise to decrease or counterclockwise to
increase the ame to proper size (see Figure 42,
page 28). Do not remove the adjustment screw.
• see Troubleshooting, page 31

Burner ames will be steady; not lifting or oating.
Flame patterns will be different from unit to unit
and will vary depending on installation type and
weather conditions.
If the vent conguration is installed incorrectly,
the ames will lift or "ghost". This can be danger-
ous. Inspect the ames after installation to ensure
proper installation and performance.
Figure 45 shows a typical ame pattern.
If burner flame pattern differs from that de-
scribed:
• turn replace off (see To Turn Off Gas to Ap-
pliance, page 28)
• see Troubleshooting, page 31
 previous next