Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
108660-01D
14
For more information, visit www.desatech.com
For more information, visit www.desatech.com
COMBUSTION AIR KIT MODEL AK4
(OPTIONAL)
The outside air kit may be installed on the left side of the fireplace
only. The vent can be installed through the outside wall or a
ventilated crawl space. The handle to operate the damper door for
the outside air inlet will be located inside the left “screen pocket” of
the firebox (see Figure 31). Pull the handle to open or push to close.
APPLIANCE ENCLOSURE
Before finishing the enclosure around the appliance, inspect all
joints around the outer surround. Any gaps between the nailing
flanges and the framing should be sealed with noncombustible
insulation or caulking (see Figure 32).
If the appliance is mounted on a raised platform, it must be a
continuous surface and not on blocks without a solid surface. This
will prevent the entry of cold air by means of conduction through the
total bottom of the appliance.
CAUTION: Air inlet ducts are not to terminate in
attic space.
Figure 31 - Air Kit Handle Location
Air Kit
Handle
Side
Framing
Side
Framing
Caulk Here
Pack Insulation
Figure 32 - Sealing Between Appliance and Framing
Screen Pocket
INSTALLATION
Log Placement For PO325/VP325 Models (Cont,)
Combustion Air Kit Model AK4 (Optional)
Appliance Enclosure
3. Rest front of log 3 between first two grate fingers on left of
grate assembly and rear of log 3 into notch on left front oflog
1(see Figure 28).
4. Place top of log 4 into notch on log 1. Rest log 4 on the center
of grate as shown in Figure 29.
5. Place top of log 5 into notch on top right of log 1 (see Figure
29). Rest log 5 between two middle grate fingers as shown in
Figure 30.
To enhance the look of the hearth you may optionally place the lava
rock provided around the front and sides of the burner.
Figure 29 - Installing Logs 4
and 5
Figure 30 - Logs Installed
Log 5
INSTALLATION
Continued
NOTICE: Do not put lava rock inside the burner pan or
around the air mixer fitting. Placing lava rock inside the
burner pan or blocking the openings of the propane/LP
air-mixer could cause performance problems.
Log 4
Log 1
Log 3
Figure 28 - Installing Log 3
Log 3
Log 1