Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
13
104887
OWNER’S MANUAL
O
F
F
P
I
L
O
T
O
N
H
I
L
O
O
F
F
P
I
L
O
T
O
N
H
I
L
O
O
F
F
P
I
L
O
T
O
N
H
I
L
O
INSTALLATION
Continued
WARNING: After installation
and periodically thereafter, check
to ensure that no flame comes in
contact with any log. With the
heater set to High, check to see if
flame contact any log. If so, repo-
sition logs according to the log
installation instructions in this
manual. Flames contacting logs
will create soot.
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
INSTALLING LOGS
CAUTION: Do not remove the
warning and instruction labels
attached to the heater base as-
sembly. These markings contain
important warranty information.
Each log is marked with a number. These
numbers will help you identify the log when
installing. It is very important to install these
logs exactly as instructed. Do not modify
logs. Only use logs supplied with heater.
1. Place the base of the middle log (#1) in
the U-shaped slots of the grate base.
The cutout on the right of the middle
log should fit over the burner (see Fig-
ure 21). Make sure the front of the
middle log is resting on the tabs of the
grate base and the cutout area is cen-
tered over the burner “U” bend.
2. Locate pegs on the bottom of back log
(#2). Slide these pegs into the holes in
the grate base behind the burner (see
Figure 22).
3. Locate the notches in the bottom of the
front log (#3). Place the front log on
the grate fingers. Make sure the notches
of the front log line up with the grate
fingers (see Figure 23).
4. Place crossover log (#4) onto the peg
(right) on back log (#2) and into the re-
cess of the middle log (#1) (see Figure 24).
Figure 21 - Installing Middle Log (#1)
Figure 22 - Installing Back Log (#2)
Figure 24 - Installing Crossover Log (#4)
Figure 23 - Installing Front Log (#3)
Middle Log (#1)
"U"-shaped
Cutout in
Base
Burner
Hole in Base
Back Log (#2)
Peg
Peg
Front Log (#3)
Grate Fingers
Notches
Crossover Log (#4)
Peg
Recess
Notches
Figure 25 - Installing Fireplace Screen
Screws for
Mounting Screen
WARNING: You must operate
this fireplace with the fireplace
screen in place. Make sure fire-
place screen is in place before
running fireplace.
Install fireplace screen by slipping notches
of fireplace screen over screws on front of
fireplace (see Figure 25).
INSTALLING SCREEN
Continued
O
F
F
P
I
L
O
T
O
N
H
I
L
O