Desa GL36CLP Fire Pit User Manual


 
www.desatech.com
112301-01D 5
Figure 2 - Typical Two Sided Fireplace
Installation
INTRODUCTION
Models (V)GL36CR(P)/CL(P) are decorative
gas replaces that use a millivolt gas control
valve with millivolt ignition system. Models
(V)GL36CR(P)E/CL(P)E use an electronic gas
control valve with electronic ignition system.
These systems require a 6" B-type vent that is not
supplied by DESA. For installation guidelines,
check your B-vent instructions.
WARNING: This gas appli-



If you are uncertain as to what gas your unit is
approved and tested for, check rating plate on
inside of replace opening or consult your local
distributor of DESA products.
BEFORE YOU BEGIN
Before beginning the installation of your appli-
ance, read these instructions through completely.
This DESA appliance and its approved compo-
nents are safe when installed according to this
installation manual and are operated as recom-
mended by DESA. Unless you use DESA approved
components tested for this appliance, YOU MAY

The DESA warranty will be voided by and DESA dis-
claims any responsibility for the following actions :
A) Modication of the appliance or any of the
components manufactured by DESA unless
otherwise permitted by DESA.
B) Use of any component part not approved by
DESA in combination with this appliance.
C) Installation and/or operation in a manner other
than instructed in this manual.
D) The burning of anything other than the type of
gas approved for use in this gas appliance.
This appliance, when installed, must be electrically
grounded in accordance with local codes or, in the
absence of local codes, with the National Electri-
cal Code, ANSI/NFPA 70-1987 and the CSA C22.1
Canadian Electrical Code for Canada.
The installation must conform with local codes
or, in the absence of local codes, with the current
National Fuel Gas Code, ANSI Z223.1/NFPA 54
or with the current CAN/CGA B149 Installation
Codes for Canada.
This appliance complies with ANSI Z21.50B-
1990 and CAN/CGA-2.22-M89 as a Vented Gas
Appliance and is listed and tested by the Omni
Test Laboratories.
WARNING: Installation and
-

  



-
    
   


NOTICE: This appliance is not

source of heat.
SELECTING LOCATION
To determine the safest and most efcient location
for your appliance, you must take into consider-
ation the following guidelines:
1. The location must allow for proper clearances
(see Clearances, page 6).
2. The location should be in a place where drafts,
air conditioning ducts, windows or doors will
not affect replace heat output.
3. A location that avoids the cutting of joists
or roof rafters will make installation easier.
Figure 2 shows a typical two-sided replace
installation.
Existing
Side
Wall
4" From Opening to
Perpendicular Wall
Access
Control Panel