Desa GL36CLP Fire Pit User Manual


 
www.desatech.com
112301-01D10
2. Prepare incoming gas line and check with local
codes regarding use of Teon tape. Complete
gas line installation by connecting incoming
gas line with exible gas line. Secure tightly
with wrench. Do not overtighten.
WARNING: All gas piping



After ensuring that the gas valve

detection solution to all con-

 
and corrected.

testing and do not operate any

LOG SET PLACEMENT
Carefully remove log set from packaging. Place
the two bottom logs over grate and align with pins.
Place three loose logs, or twigs, onto alignment
pins on two bottom logs (see Figure 16).
FIREPLACE
INSTALLATION
Continued
FIREPLACE FACING
Any noncombustible material may be used for
facing (glass, tile, brick, etc.) as long as the proper
clearances are adhered to and the replace open-
ings are not blocked or obstructed in any way. See
Clearances, page 6, and Figure 17.
Use only heat resistant, noncombustible mortar
or adhesive when securing facing material to the
front of the replace.
Figure 16 - Log Placement
GLASS DOOR
When replace is in operation, glass doors must
be either fully open or fully closed position (see
Figure 18).
Figure 17 - Fireplace Facing Material
Noncombustible
Facing Material
Do Not
Block
Effective
Opening
"L" Shaped
Metal Support
Noncombustible
Facing Material
Bottom Logs
Top Logs (Twigs)
Figure 18 - Glass Doors Shown Fully
Open
Glass Doors Must be Fully Open
(as Shown) or Fully Closed when
Appliance is in Operation
Right
Corner
Opening
Left
Corner
Opening