Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
www.desatech.com
112462-01B 13
Mantel Shelf
Side of Firebox
13"
16"
19"
21"
2
1
/
2
"
6"
8"
10"
Note:
All vertical
measurements
are from top of
fireplace
opening to
bottom of
mantel shelf. All
measurements
are in inches.
Figure 10 - Minimum Mantel Clearances
for Built-In Installation
INSTALLATION
Continued
OPTIONAL MANTEL INSTALLATION
Note:
Refer to instructions provided with the man-
tel for assembly instructions. Refer to the follow-
ing instructions for system installation. Refer to
instructions on page 5 for fireplace assembly.
Blower accessory should be installed if it is being
used (see Installing Blower Accessory GA3450T,
page 14).
1. Unscrew four screws that attach top louver to
fireplace. Remove louver from fireplace and
set aside.
2. Place fireplace on wood base.
3. Place mantel around fireplace/base assembly.
4. Assemble trim kit. See Assembling Trim,
page 14.
5. Firmly snap trim kit on shoulder screws.
Shoulder screws are located on fireplace cabi-
net (see Figure 11).
6. Align trim kit for flush fit around opening.
7. Use two 3" wood screws provided and attach
fireplace base to wooden base. There are holes
provided on each side and floor of firebox (see
Figure 11).
8. Place base assembly next to wall at installa-
tion location.
9. Remove trim kit and mantel. Be careful not
to damage wall or mantel.
10. Attach wood base to floor with two 1
3
/4" black
screws provided (see Figure 12). If the floor
is concrete use anchor method (see Attaching
Wood Base to Solid Floor, page 17).
11. Install gas line. See Connecting To Gas Sup-
ply, page 17.
12. Check for leaks. See Checking Gas Connec-
tions, page 19.
13. Place mantel around fireplace. Be careful not
to damage wall or mantel.
14. Place trim kit on the shoulder screws located
on the side and top of the fireplace. Firmly
snap the trim over the shoulder screws on fire-
place (see Figure 11).
15. Adjust assembly to remove any gaps. Attach
remaining two 3" wood screws from hardware
pack through openings inside of fireplace sides
into the mantel. The openings are located at top
behind the area for the louvers (see Figure 11).
16. Reinstall top louvers.
Figure 11 - Attaching Trim to Fireplace
Shoulder
Screws
Assembled
Trim
Shoulder Screws
Hole for
Attaching
Fireplace
to Mantel
Figure 12 - Attaching Wood Base to
Floor
1
3
/4" Screw
Wood Base