Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
111410-01C
For more information, visit www.desatech.com
For more information, visit www.desatech.com
15
15
Figure 26 - Checking Gas Joints for Propane/LP Units (Shown
with Optional Mantel)
Equipment Shutoff Valve
Propane/LP
Supply Tank
INSTALLATION
Continued
Pressure Testing Fireplace Gas Connections
1. Open equipment shutoff valve (see Figure 24, page 14).
2. Open main gas valve located on or near gas meter for natural
gas or open propane/LP supply tank valve.
3. Make sure control knob of fireplace is in the OFF position.
4. Check all joints from equipment shutoff valve to thermostat
gas valve (see Figure 23, page 14). Apply noncorrosive leak
detection fluid to gas joints. Bubbles forming show a leak.
5. Correct all leaks at once.
6. Light fireplace (see Operating Fireplace, pages 16 and 17).
Check all other internal joints for leaks.
7. Turn off fireplace (see To Turn Off Gas to Appliance, page 16).
8. Replace front panel.
WARNING: Failure to position the parts in accor-
dance with these diagrams or failure to use only parts
specifically approved with this heater may result in
property damage or personal injury.
INSTALLING LOGS
It is very important to install the logs exactly as instructed. Do not
modify logs. Only use logs supplied with heater.
Place one-piece log set on grate to fit as illustrated in Figure 27.
Make sure back section of log set is seated into “U”-shaped cutout
in center of chassis (see Figure 27).
IMPORTANT:
Make sure log
does not cover any burner ports (see Figure 28).
CAUTION: After installation and periodically there-
after, check to ensure that no flame comes in contact
with any log. With the heater set to HI, check to see if
flames contact any log. If so, reposition logs accord-
ing to the log installation instructions in this manual.
Flames contacting logs will create soot.
L
O
PILO
T
O
FF
HI
One Piece Log Set
"U"-shaped
Cutout in
Chassis
Chassis
Figure 27 - Installing One-Piece Log Set
Figure 28 - Installing One-Piece Log set (Top View)
One Piece Log Set
Burner Ports
Burner
INSTALLATION
Checking Gas Connections (Cont.)
Installing Logs