Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
Grill Assembly
9
1. The Grease Diverter is installed without tools. It is to be located right
below the burners with four tabs inserted into four slots (Fig. 19).
2. Install the Grease Diverter from above by slipping it down between the
burners and through the opening in the grill firebox (Fig. 17).
3. Once it is below all the burners, position it horizontally (Fig. 18) and
align the four tabs (at the corners) with the four slots. A slight amount
of spring tension in the diverter will hold it in place when the tabs are
positioned in the slots (Fig. 19).
1. Place part of the shipping carton behind the grill for protection. Lay the
grill on its back to assemble the four wheels (Fig. 14).
2. Assemble the locking wheels at the front of the grill. Secure each
wheel with four screws each.
3. Carefully lift the grill cart upright onto the wheels.
Fig. 14
Fig. 20
Fig. 21
Fig. 15
1. Remove four screws at location “F”. These are the mounting screws
for the windscreen (Fig. 15).
Fig. 16
2. Attach the windscreen with four screws (Fig. 16).
F
Fig. 17 Fig. 19Fig. 18
2. Carefully place the Grill Lid
onto the grill frame in the
closed position (Fig. 23).
1. Hardware to attach the grill
lid are two pins, washers,
and hairpin cotters (Fig. 22).
Fig. 22
3. Insert each pin through the
lid and windscreen (Fig. 24).
Fig. 24
Fig. 23
4. Carefully raise the lid to the
open position (Fig. 25).
Fig. 25
Assemble the Grill Lid
Assemble the Heat Tents
and the Cooking Grates
Assemble the Grease Diverter
Assemble the Wind Screen
Assemble the Wheels