Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
17
CAUTION
All cleaning and maintenance should be done only when the
grill is cool & with the fuel supply turned off at the cylinder.
Suggested Cleaning Materials:
• Mild dishwashing liquid detergent • Hot water • Wire brush
• Paper clip • Nylon cleaning pad • Soft brass-bristled brush
• Putty knife • Scraper
Component Cleaning:
• BURNER: Wire-brush loose corrosion from the burner exterior.
Clean clogged gas port holes with an opened paper clip.
Replace corroded or damaged burners that would emit excess
gas.
• STAINLESS STEEL: Clean with any multipurpose (low abrasive,
non phosphorous) metal polish or stainless steel polish and a soft
cloth to prevent marring or scratching the surface. NEVER
USE OVEN CLEANER!
• COOKING GRATES: Clean cooking grates with mild soap and
hot water. Remove stubborn residue with a mild cleanser or
scrub brush. DO NOT use a commercial oven cleaner.
• HEAT TENTS: Wipe off grease residue using a cleaning pad
and a brass-bristle brush to knock off residue. Replace heat
tents to their correct position.
• GRILL INTERIOR: Remove grates and heat tents.
Scrape side with tools and remove excess grease and cooking residue.
Care, Maintenance and Cleaning
(continued)
REPRESENTATIVE ILLUSTRATION
WARNING
Spider’s nests or wasp’s mud inside the venturi may cause
fire at the valve. If a fire occurs, immediately
turn off the
gas supply at the L.P. cylinder valve (see representative
illustration in Fig. 51).
Note:
Spiders and small insects can spin webs and build nests inside the
venturi tubes.This especially occurs in late summer and fall before
frost when spiders are most active. These nests can obstruct gas
flow and cause a fire in and around the burner valves. Such a fire
can cause operator injury and serious damage to the grill. To help
prevent a blockage and ensure full heat output, clean and inspect
the venturi tubes often (once or twice a month). NOTE: Water or air
pressure will not
normally clear a spider web.
Steps For Cleaning Venturi:
1. To remove the above obstructions, use an accessory flexible venturi
brush or bend a small hook on one end of a 20-inch long flexible wire
such as the one shown in Fig. 52.
Fig. 51
Fig. 52
STAINLESS STEEL
After initial usage, areas of the grill may discolor from the intense
heat given off by the burners, this is normal and not considered
a defect.
Purchase a mild stainless steel cleaner and rub in the direction of
the grain of the metal. Specks of grease can gather on the surface
of the stainless steel and bake on to the surface and give a worn
appearance. For removal, use an non-abrasive oven cleaner in
conjunction with a stainless cleaner.
NOTE: Always scrub in the direction of the grain.
BATTER
Y REPLACEMENT (FOR IGNITER):
The igniter is powered by a standard 9 Volt battery. To replace the
battery, locate the igniter module by opening the right side door.
The igniter module is located near the top edge of the right side
panel. When installing a fresh battery, observe polarity as marked
on the igniter module and push in firmly (Fig. 50).
Fig. 50
9 Volt Battery
Igniter
Module
Cleaning the Venturi