Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
1.
Place a piece of styrofoam from the packaging in the grill to
leave the grill hood propped open slightly (Fig. 6).
2.
Position the side shelf hooks with the slots on the side of the
grill, near the back (Fig. 7).
3.
Position the side shelf flange over the inside top edge of the grill
(Fig. 8). Push the side shelf downward to engage the hooks and
the flange at the same time, until the top surface is level with the
grill (Fig. 9).
4.
Secure the front of the shelf by inserting (2) self tapping screws
into the front flange underneath the shelf. Use a 1/4” hex nut
driver as shown (Fig. 10), or use a power tool whenever there is
enough room.
5.
Secure the rear of the shelf by inserting (1) self tapping screw in
the back of the grill and through the shelf tab. (Fig. 11).
Left Side Shelf Attachment
Grill Assembly — 8100 Series
IMPORTANT: Remove all protective plastic film from stainless
steel parts prior to assembly/use. This film is installed at the
factory to prevent damage that could occur during shipment
and handling.
Fig. 7
Fig. 8
Fig. 9
Fig. 10
10
Fig. 11
Fig. 6
Tools Required (not provided):
— 1/4” Hex Nut Driver
— Phillips Screwdriver
Optional:
— Battery Powered 1/4” Hex Nut Driver