Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
English - 5
■ Remove plastic cap from
top of propane cylinder
and screw cylinder into
regulator hand tight.
(Fig. 19)
■ Before attaching propane
cylinder make sure
burner knob is in the OFF
position. (Fig. 18)
Installing 1 lb. Propane Cylinder
rNEVER store a spare L.P. gas supply cylinder under the
grill body or inside the grill enclosure or in the vicinity of
any heat producing appliance.
Failure to follow this information exactly could result in an
explosion and/or re causing death or serious injury.
DANGER
Tighten by hand only. DO NOT use tools.
CAUTION
Only cylinders marked “Propane” must be used.
WARNING
This procedure MUST be performed OUTDOORS only!
Read and follow the directions on the cylinder.
WARNING
Burner and Orifice
Fig. 18
■ To open lid, unlatch
handle cover and lift up.
(Fig. 20)
■ Place grill grate over the
burner. (Fig. 21)
Fig. 20
Fig. 21
Fig. 19
NOTE: Your 9955 Series grill is set up from the factory to
use a 1 lb. disposable propane cylinder.
■ Install drip tray below
rear of grill. (Fig. 15)
■ Plug the round electrical connector to the round jack at
the end of the electrical igniter, and insert the at one
through the burner tube hole, then screwed with screw.
(Fig. 16 and Fig. 17)
Install the Drip Tray
Install the Electrode and Ground Wires
Fig. 15
Fig. 17
Orifice Fitting
Fig. 22
Burner Burner Tube
■ Proper location of the burner with respect to the orice is
important. To verify the proper installation of the burner
tube, view under the regulator assembly cover. The
burner tube must be located over the orice tting. See
Fig. 22 (grill top not shown).
Fig. 16
Flat
Round
Burner Tube
Hole