Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
17
Do not attempt to light the grill if odor of gas is
present. Call for service 1-800-913-8999.
LIGHTING INSTRUCTIONS
WARNING: IMPORTANT!
BEFORE LIGHTING…
Inspect the gas supply hose prior to turning the gas
“ON”. If there is evidence of cuts, wear, or abrasion, it
must be replaced prior to use. Do not use the grill if
the odor of gas is present. Only the pressure regulator
and hose assembly supplied with the unit should be
used. Never substitute regulators for those supplied
with the grill. If a replacement is necessary, contact
the factory for proper replacement.
Screw the regulator (type QCC1) onto the tank. Leak
check the hose and regulator connections with a soap
and water solution before operating the grill
TO LIGHT THE GRILL BURNER:
Make sure all knobs are “OFF” then turn on the gas
supply from the LP tank. Always keep your face and
body as far from the grill as possible when lighting.
Your grill has an exclusive patented built-in ignition.
The igniter is built in to the valve. To ignite each
burner simply push and turn the control knobs to the
HI setting, you will hear the valve click as it sends a
spark to the pilot flame. If the burner does not light,
wait 5 minutes for any excess gas to dissipate and
then retry.
Flame Characteristics
Check for proper burner flame characteristics. Each
burner is adjusted prior to shipment; however,
variations in the local gas supply may take minor
adjustments necessary.
Burner flames should be blue and stable with no
yellow tips, excessive noise, or lifting. If any of
Visually check the burner flames prior to each use, the
flames should look like this picture, if they do not, refer to
the burner main tenancies part of this manual
these conditions exist call our customer service line. If
the flame is yellow, it indicates insufficient air. If the
flame is noisy and tends to lift away from the burner, it
indicates too much air.
TO MATCH LIGHT THE GRILL:
If the burner will not light after several attempts then
the burner can be match lit.
If you’ve just attempted to light the burner with the
igniter, allow 5 minutes for any accumulated gas to
dissipate. Keep your face and hands as far away from
the grill as possible. Insert a lit extended match or
lighter through the cooking grids to the burner. Press
the control knob and rotate left to the HI setting,
continue to press the knob until the burner ignites.
Burner should light immediately. If the burner does not
light in 4 seconds turn the knob off, wait 5 minutes
and try again.
TO LIGHT THE ROTISSERIE BURNER:
Open the lid; push the knob for about 5 seconds
without rotating. This will allow time for the gas to flow
into the rear burner. Continue pushing for 5 seconds
then turn the knob to the HI position, then press the
igniter button to light the rotisserie burner. If the
burner does not light, turn the control knob to “OFF”. If
the igniter does not function, follow the instruction
above for match lighting.
Keep a spray bottle of soapy water near the gas
supply valve and check the connections before
each use.
Approximate
1 1/2“ Flame
Height
K15Y06P-1