Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
8a
18
23
Insert sideburner into left shelf. The stud on bottom of burner fits into rear small hole in sideburner drip pan on shelf,
shown A. Make sure burner tube engages sideburner valve, shown C. Secure burner to siderburner drip pan with one Wing
nut, shown B. Under sideburner shelf, attach sideburner ignitor wire to electrode.
sideburner
Wing nut
electrode
ignitor wire
sideburner drip pan
sideburner drip pan
burner tube
A
B
C
valve
17
#8-32x3/8” screw
4mm
lock washer
Control knob
Side burner
bezel
First, remove the two screws and lock washers attached to the sideburner valve bracket. Position sideburner valve
bracket beneath sideburner control panel so that valve stem comes through larger center hole in control panel. Align the
holes on valve bracket with left and right holes on control panel. Secure using lock washers and screws that were removed
from bracket.
Next, place sideburner bezel over valve stem on front side of control panel. Align small holes on bezel with upper and lower
holes on control panel. Attach using two #8-32x3/8” screws and 4mm lock washers. Press sideburner control knob onto
valve stem.
Sideburner
valve bracket
Sideburner
control panel
Valve stem
Screws and Washers
removed from valve bracket
Note: Use left and right
holes on control panel
to attach valve bracket
holes on control panel
to attach bezel
Note: Use upper and lower
Note: Make sure to set the bezel with
the longer slot at the top