Char-Broil 463251012 Gas Grill User Manual


  Open as PDF
of 40
 
12
19
13
Inside of the cart, connect the wires from burner electrodes into the back of Electronic Ignition module. Total (5) connections.
Note: Switch terminals are larger than electrode terminals and should only be installed in location shown as (a),(b).
Connect the two wires [(a) and (b)] from switch wiring harness into the back of Electronic Ignition module. Total (2)
connections, shown A.
1
(a)
(b)
2
3
4
5
Electronic ignition module
+
-
Cap
AA battery
Right side panel
C
A
B
Nut
Electronic ignition
Tie wrap
Right side panel
module
NOTE: Wires omitted for
clarity of illustration
Unscrew the cap and nut from electronic ignition module. Attach electronic ignition module to the cart right side panel
with the nut, shown B.
Insert AA battery into ignition module, negative (
–) end first. Then put on the cap, shown C.
Attach right side control panel to right side shelf using four #10-24x3/8” screws, 5mm lock washers and 5mm flat washers,
shown A.
Insert flange on right side shelf into side shelf brackets on right side of firebox, shown B.
#10-24x3/8” screw
5mm lock washer
5mm flat washer
A
B
side shelf bracket
 previous next