Char-Broil 463247310 Charcoal Grill User Manual


 
10
Insert front brace under control panel and between cart side panels. Make sure door hinge pins are on the top side and
facing the front. Secure using two 1/4-20x1½” screws, 7mm lock washers, and 7mm flat washers on each side.
NOTE: MAKE SURE THAT THE FRONT BRACE IS MOUNTED IN THE MOST DOWNWARD POSITION WHEN
ASSEMBLED TO CART.
11
#8-32x3/8” screw
4mm
lock washer
Control knob
Control knob
bezel
First, remove the two screws and lock washers factory attached to the sideburner valve bracket. Position sideburner
valve bracket beneath sideburner shelf fascia so that valve stem comes through larger center hole in fascia. Align the holes
on valve bracket with left and right holes on fascia. Secure using lock washers and screws that were removed from bracket.
Next, place sideburner bezel over valve stem on front side of fascia. Align small holes on bezel with upper and lower holes on
fascia. Attach using two #8-32x3/8” screws and 4mm lock washers. Press sideburner control knob onto valve stem.
Install bezel with “OFF” at top.
Sideburner
valve bracket
Sideburner
fascia
Valve stem
Screws and Washers
removed from valve bracket
Note: Use left and right
holes on fascia to
attach valve bracket
holes on fascia to
attach bezel
Note: Use upper and lower
1/4-20x1½”
7mm lock
washer
7mm flat
Front brace
washer
screw
20