Centro 3000 Gas Grill User Manual


 
1
ADDITIONAL
WARNINGS
INSTALLATION
INFORMATION
The installation of this appliance must be in accordance with all local codes, or in the
absence of local codes:
Canadian installation must conform to the current national standards, which at this time
are CAN/CGA-B149.1/2-Natural Gas/Propane installation code.
Drawing A
Minimum clearance to adjacent combustible materials:
76 cm (30˝) from furthest protruding edge on side of barbecue.
76 cm (30˝) from furthest protruding edge on back of barbecue.
See Drawing A
Always keep the area around this barbecue clean and clear of any and all combustible
materials such as gasoline or other inflammable liquids, paper or oily rags.
Do not operate this barbecue under any overhanging or unprotected construction.
Remember this barbecue is for outdoor use only and is not for use on any boat or
recreational vehicle.
Use this barbecue outdoors in a well-ventilated area and at least
3 m (10’) from any dwelling or other building.
Do not use in garages, or any other enclosed area.
Do not leave your barbecue unattended while in operation.
Do not obstruct the flow of combustion and ventilation air to the barbecue.
Do not use while under the influence of drugs or alcohol.
Do not store any spare L.P. (propane) cylinders, full or empty,
under or near your barbecue.
Do not allow children or pets to play anywhere near the barbecue.
USE OF LP GAS CYLINDER
Self-contained
Propane Gas System
The self-contained (propane) gas system barbecue is designed to be used with only a 9.1 kg
(20 lb) propane cylinder equipped with a type-1 cylinder valve. This barbecue cannot be
connected to an existing #510 P.O.L. type valve cylinder (which has left-handed threads).
Do not connect to a propane gas cylinder exceeding 9.1kg capacity or use a cylinder
with any other type of cylinder valve connection device.
The Type-1 valve can easily be recognized by the large external thread on the outside of the
valve. Older existing valves do not have this outer external thread. Any attempt to connect
a regulator to any connector other than the mating Type-1 connector (which comes with a
large, black coupling nut such as the #510 P.O.L.) could result in fires, injuries or property
damage, and could reduce the effectiveness of the important safety features built into the
Type-1 system. Also connecting the #510 P.O.L. fitting to the cylinder will negate the flow
control and the temperature shut-off features built into the new Type-1 connection system.
The cylinder should not exceed 472 mm (18 1/2˝) in height and
317 mm (12 1/2˝) in diameter.
When purchasing a cylinder for your barbecue, it must be constructed and marked
as meeting the specifications of:
Canada: Transport Canada.
Minimum clearance of 76cm (30”)
on both sides and back of the barbeque.