Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
· Open Hood before lighting the grill to prevent an
explosion from gas build-up.
· Always inspect the gas hose and regulator
assembly before each use. If the hose is cut,
damaged, or showing signs of excessive abrasion
or wear, do not use the LP gas grill. Contact the
manufacturer, as the hose must be replaced
with an assembly specified by the manufacturer
prior to further use of the LP gas grill.
How to manually light your LP gas grill
1) Open Hood and Control Panel Cover.
2) Important: The LP gas cylinder valve must be
opened first before turning the control knobs on the
grill. Turn the LP cylinder valve counter- clockwise
until it stops.
3) Using the match Wire Holder (Item 25), light a
match and insert it through the match-lighting hole
underneath the left side table on the grill Body. Hold
lit match near burner(See figure below).
4) Locate the control knob that corresponds to the match
lighting hole that you are using. Push in and turn the control
knob counter-clockwise until a click is heard.
WARNING: If the burner fails to ignite after
following the above procedure, turn all the knobs
to
the “off” position and close the valve on the LP gas
cylinder. Wait five minutes and repeat all of the above
manual lighting procedures. If the grill still fails to light,
see the Troubleshooting page.
5) Light the remaining burners from left to right by turning the
control knob counter-clockwise. Your grill has a crossover
ignition system that allows the burners to light successively
off one another. Confirm each burner is lit before
lighting another burner.
6) After ignition, burners should be burned at the “high” position
for 3-5 minutes in order to preheat the grill. This process
should be done before every cooking session. The hood
should be closed during preheating.
WARNING: If a burner goes out during the cooking
cycle, turn all knobs to the “off” position and close the
valve
on the LP cylinder. Open hood and wait five minutes
before attempting to relight the grill. Always leave Control
Panel Cover open during use to prevent excess heat buildup
and damage to your grill.
Manual Lighting of the Grill
19