Filter
Top Products
Special offers from our partners!
Find Replacement BBQ Parts for 20,308 Models. Repair your BBQ today.
· Wash the porcelain coated Cooking Grids with a
mixture of hot water and soap.
· Empty the foil pan and grease tray after each cook-
ing session so excessive grease does not accumulate.
Failure to remove grease may result in grease
dripping onto the cart and/or a grease fire in the
tray.
· Open Hood before lighting the grill to prevent an
explosion from gas buildup.
· Always inspect the gas hose and regulator
assembly before each use. If the hose is cut,
damaged, or shows signs of excessive abrasion
or wear, do not use the LP gas grill. Contact the
manufacturer, as the hose and regulator assembly
must be replaced withan assembly specified by
the manufacturer prior to further use of the LP
gas grill.
3) From the “Off” position, push control knob in on the left
burner and turn counter-clockwise until you feel resistance.
Pause 4 seconds, then continue turning the control knob
until a click is heard and the burner is lit.
4) Light the remaining burners by turning the control knob
counter-clockwise. Your grill has a crossover ignition system
that allows the burners to light successively off one another.
Confirm each burner is lit before lighting another burner.
5) If any of the burners do not light, repeat Step 3. The burner
should light within three or four attempts. If burner still does
not light, try the next burner from left to right.
WARNING: If any or all burners fail to light after
following Steps 3 & 4, turn all knobs to the “off”
position and close the valve on the LP gas cylin-
der.
Wait five minutes; then repeat all of the above lighting
procedures.
Note: If the burners still fail to light, refer to the
Troubleshooting page. The burner can be lit manually. See
Manual Lighting of the Grill.
6) After ignition, preheat the grill by turning the control knob to
“High” position for 3-5 minutes. The grill should be
pre-heated before every cooking session.
WARNING: If a burner goes out during
the cooking cycle, turn all knobs to the “off” position and close
the
valve on the LP gas cylinder. Open hood and wait five min-
utes before attempting to relight the grill. Always leave the
Control Panel Cover open during use to prevent excess
heat buildup and damage to your grill.
Preparation Before Cooking
Lighting the Grill Using the Integral
Ignition System
How to light your LP gas grill (See diagram on next
page for illustrations)
1) Open Hood and Control Panel Cover.
2) Important: Make sure control knobs are turned “off” first.
The hood should be closed during preheating.
18
Open the LP gas cylinder valve by turning the valve counter-
clockwise until it stops.